D-BOLT TYP 42 (AP-058)
Single impact point made of steel, painted yellow, for concrete ceilings for gluing in
- Single anchor point, especially for concrete substrates (dmin: 170 mm)
- The anchor rod with external thread is attached using injection mortar (not included in the scope of delivery) (Klebanker), AK 1, approval for 3 persons
Product information "D-BOLT TYP 42 (AP-058)"
The single anchor point D-BOLT AP-TYP-42 is tested and certified according to EN 795, CEN/TS 16415 and has a general technical approval (abZ) from the German Institute for Building Technology (DIBt). It is made of quenched and tempered steel 1.0503, is yellow painted and has been specially developed for use on concrete substrates (grade min. C20/25, dmin.=170 mm). It is fixed with an M16 anchor rod with external thread, which is glued into the concrete with an approved injection mortar (not included). It can bear loads in all directions and can secure up to three people from falling with their PPEgA. The minimum thickness of the base is 170 mm.
- Single anchor point, especially for concrete substrates (dmin: 170 mm)
- Fixing of the anchor rod with external thread is done by means of injection mortar (not included in delivery) (Klebanker), AK 1, approval for 3 persons
PRODUCT
-
Application areas
-
Maximum lifetime
-
Maximum load
-
Rope access technique
-
Thickness mounting base
-
Usable in SEAL PAC
-
Type mounting base
-
Mounting type
-
Min. height
-
Max height
-
Anchor point type
-
Max. number of persons
-
Minimum area required
-
Maximum area required
-
Material