D-BOLT TYP 43 (AP-058)
Single impact point made of steel, painted yellow, for concrete ceilings for gluing in
- Single anchor point, specifically for concrete substrates (dmin: 160 mm)
- The anchor rod with internal thread is secured using injection mortar (not included) (adhesive anchor), AK 1, approved for 3 people
Product information "D-BOLT TYP 43 (AP-058)"
The D-BOLT AP-TYP-43 single anchor point has been tested and certified in accordance with EN 795 and CEN/TS 16415 and has a general building authority approval (abZ) from the German Institute for Building Technology (DIBt).
It is made of heat-treated steel 1.0503, has a yellow finish, and was specifically developed for use on concrete substrates (grade min. C20/25, dmin.=160 mm).
It is secured using an M16 anchor rod with an internal thread, which is bonded into the concrete using an approved injection mortar (not included).
It can withstand loads in all directions and can protect up to three people from falling using their personal fall protection equipment (PPE).
The minimum thickness of the substrate is 160 mm.
- Single anchor point, specifically for concrete substrates (dmin: 160 mm)
- The anchor rod with internal thread is secured using injection mortar (not included) (adhesive anchor), AK 1, approved for 3 people
PRODUCT
-
Application areas
-
Maximum load
-
Rope access technique
-
Thickness mounting base
-
Usable in SEAL PAC
-
Type mounting base
-
Mounting type
-
Min. height
-
Max height
-
Anchor point type
-
Max. number of persons
-
Minimum area required
-
Maximum area required
-
Material